MXD4000 Digital Preamp Processor

MXD4000 Digital Preamp Processor

Need assistance?

You can place an order via the telephone during office hours on 0844 800 8528.

For general enquires about an existing order, please call us during office hours on 0844 800 8528.

Office Opening Hours: Monday to Friday:
9am – 5.30pm

MXD4000 Digital Preamp Processor

The Myryad MXD4000 Digital Preamplifier­Processor has been designed to offer a combination of high quality audio and video performance with simple yet elegant styling. The MXD4000 forms the heart of a high­end home cinema.

  • Digital-to-analogue conversion: 8 channels, delta-sigma, 24bit 192kHz
  • Analogue-to-digital conversion: 2 channels, delta-sigma, 24bit 96kHz
  • Stereo sources may be sampled at 48kHz or 96kHz as desired
  • 24bit 96kHz capable digital inputs
  • Three HDMI digital video inputs – each assignable to any of ten sources
  • Three component video inputs – each assignable to any of ten sources
  • Six composite video and four s-video inputs – each assignable to any of ten sources
  • Video transcoding (with OSD available on transcoded video):
    – Composite to S-Video – Composite to component video (Y/Pb/Pr)
    – S-Video to component video (Y/Pb/Pr)
  • Simple intuitive menu system for setup
  • Comprehensive bass management:
    – Hybrid digital/analogue bass management optimises dynamic range under all
    conditions
    – Crossover frequency can be set between 20Hz and 200Hz in 5Hz steps
    – Subwoofer can be fed a ‘flat’ signal to allow the sub’s own filter to be used
  • 7.1 channel analogue bypass input
  • Analogue domain bass management on 7.1 channel input Options: all Large,
    only LF/RF Large, or all Small. HPF crossover fixed at 80Hz, 2nd order
  • Loudspeaker distances can be set in feet or metres
  • Lip sync correction (audio delay up to 150ms)
  • Five separate preset setups (speaker levels, bass, treble and lip sync) can be stored
    and assigned to specific sources
  • Stereo analogue input sensitivities individually adjustable
  • Analogue Monitor allows metering of stereo input signals levels – with automatic
    setting of sensitivities if desired
  • Comprehensive control of remote trigger outputs from a wide variety of controlling
    sources
  • Supplied with Universal Remote Controls’ MX-700 remote, pre-programmed with all
    Myryad remote codes – including ‘discrete’ codes not sent by other Myryad handsets.
  • RS-232 interface can be used both to control the unit and to carry out the setup
  • Two Xantech-compatible IR input jacks
  • Second zone output: stereo audio plus composite video
  • Smart My-Link® communications to other Myryad products